Sold Out
Short 2u 400mm for Itx and Micro Atx Mainboard. Takes Standard Psu has vented lid not shown in image for 120mm Psu
Main Points
Technical Parameters:
• Model: D214
• Dimensions: 482(W)*390(D)* 89 mm(H)
• Main Board: 9.6"* 9.6"(245*245MM)
• Hard Disk: Four 3.5-inch Hard Disks
• CD-ROM: Two 5.25-inch CD-ROM
• Power Supply: Ordinary Desk-type ATX Power Supply PS2
• Fan: Two 8025 Fans
• Expansion Slot: Four Half High and Straight Slots
• Panel Setting: Two USB3.0; One Power Switch; One Restart Switch; One Power Indicator; One HD Indicator
• Case Material: Ma Steel flowers-free zinc plating
• Material Thickness: 1.0MM
Collections: 2u Rackmount Cases, Rackmount Cases
Category: 400mm, ATX 8cm Fan, Direct Attach, Maximum Depth 400mm, Maximum Depth 500mm, Maximum Depth 600mm, Maximum Depth 800mm, Micro Atx, Mini ITX, X-Case
United KingdomOverall satisfied with the quality of the case and it has enough space for my use case. I used the following components: 1) mini ITX motherboard 2) ATX PSU with top facing fan 3) 4x3.5 HDD 4) 1x2.5 SSD (inside the 5.25 bays with an adapter) 5) small form factor CPU cooler Pros: 1) Good use of space 2) Supporting high amount of drives (assuming you use a mini ITX motherboard) 3) Can disassemble most inner metal parts for easier access when building the system 4) Decent material quality for price 5) Supports standard PSU Cons: 1) When all components are inside the base of the case may slightly bend if you don't support it equally on all corners. Make sure you use strong rails or a strong shelf, to avoid just supporting the case from the front. 2) Quite sharp edges inside on metal components 3) Screws are not magnetized. Some screw positions are very hard to get to if you have sausage-like fingers like me Caveats: 1) Check your motherboard's SATA slots before building. In my case they were quite close to the HDD cages, which made the build much harder since I had very little space to connect the cables 2) Ensure you have a long and thin phillips screwdriver for the drive cages 3) Cable management is what you'd expect from such a small case Would recommend this case for this price range.
United KingdomGood quality short case. Advantages are that it takes a standard size ATX power supply, it has good airflow using standard large fans which are quieter than small ones often used in shallow cases, there is a foam intake filter which reduces dust and can be hoovered without removing it and it has plenty of drive bays. Only mod I've made is a 100Kohm variable resistor in the fan power lead to slow the fan speed, otherwise they are louder than I would like for home use. A 1/2U blank rack panel can be used to support case at rear when fully loaded if you don't need sliding rails.
United KingdomCase arrived safely and quickly. Case is easy to build into and does the job of a cheap rackmount very well. Edges of metal on the inside are a bit sharp but for the price you cant expect the finish of a more expensive case.
United KingdomGreat service, fast dispatch and delivery excellent customer service and great value
United KingdomEasy to use. Well set out nice build overall. Bit tight on space but expected as it’s a 2u case. Like the addition of the vents in the lid by the psu allowing other psu’s to be used.
